Tecrostar mezzanines and stairs are supplied with everything you need to install the kit at its maximum surface area or height.

• All the beams and columns
• The floor panels
• All the nuts and bolts
• Wall anchors
• Assembly manual
• Anchors for anchoring the columns to the floor

Personalised phone or email service from our specialists

It will be delivered in one or various boxes, depending on the order (check this section to see the dimensions of the boxes). The box contains everything you need to assemble it at its maximum height and surface area.

No, it is not a customised mezzanine but its telescopic design enables an almost customised finish. This system is length and height adjustable, achieving the preferred measurements. The components are small and light (less than 2.4m) and are easy to transport, in lifts, fitting through doors or windows to the place of installation, as the beams are spliced in the middle.

The height of all models can be adjusted at 12cm intervals and the length at 10cm intervals. So the mezzanine can be adjusted from its minimum values to its maximum values at these intervals.

You can choose between several types of stairs:

• Straight stairs

• Spiral stairs

• Ladders

• Retractable ladders

• Alternating tread stairs

The stairs can be placed in different positions, increasing the possible configurations

Case 1: Exterior stairs, perpendicular to the mezzanine.

Case 2: Interior stairs. You will need a beam for interior stairs.

Case 3: Exterior stairs, parallel to the mezzanine. You will need a stair landing.

Case 4: A different placement to our mezzanines.

Yes, provided that the height matches. All our stairs can be located in any of our structures. As the structures, the stairs are height-adjustable. We have several different types of stairs, to ensure the height compatibility with the selected mezzanine.

Yes. They have the exact same specifications as the initial structure.

Yes, you can add an extension to an existing mezzanine. You do not need to buy both structures at the same time.

No, the extension cannot be integrated and share columns. However, structures can be placed side by side and achieve continuity of the floor but you will not save any columns and there will be two columns together at the joints.

To install Tecrostar mezzanines you need 2 adults (they do not need to be DIY experts). It is recommendable to use personal safety equipment like gloves, boots, etc. in order to avoid accident.

When installing range L mezzanines you may need to use some type of scaffolding or ladder for working at heights and manual or electric lifting machinery to raise the primary beams, particularly if the structure is more than 3m high. The other ranges can be lifted easily by hand.

You will need the following tools to install the mezzanines: tape measure, some type of spanner for m10 and m8 bolts and a screwdriver (an electric screwdriver will make the task much easier), spirit level, drill and a tool for cutting the panels (saw, jigsaw, circular saw, etc.)

You can find all the tools required to assemble it and tested by Tecrostar in the tools section.

All the models are installed by following these steps:

Pre-assemble the structure on the floor in the desired area.

Raise the outer structure to the desired height.

Finish assembling the structure and floor.

Yes, you can. As they are manufactured with light steel profiles with a high yield point they are very light and the load per column is very low. The only restriction is the storage load on the mezzanine: instead of 200kg/m², it may be reduced to 800kg for the whole mezzanine.  A home with a concrete structure usually supports a point load of at least 200kg on a surface of 5x5cm. The T8 mezzanine weighs 199kg and the T15 mezzanine weighs 356kg, both weights are distributed over 4 columns. You can install either of these two metal mezzanines in your home, provided that the load stored on them is limited.  Ask Tecrostar about the specific features of your project.

You can do it yourself with the help of a friend. It is easily installed in a few hours, depending on the product.

TS8 Mezzanine: 3 hours with 2 people

TM15 Mezzanine: 4 hours with 2 people

TL30 Mezzanine: 5 hours with 3 people

The times are a guideline and for assembly only. You need to add the time it takes to measure up, move the components to the location, clean up, etc.